Desoldering Wick

15.00 10.00

Desoldering wick for removing solder from printed circuit boards.

100 in stock

Add to Wishlist
Add to Wishlist


1. 1.5m length.
2. 3.0mm width.
How to use:-
Place the desoldering wick over the solder to be removed, then push the heated soldering iron tip onto the desoldering wick, the solder will be absorbed.
Remove the desoldering wick after the solder has been absorbed.
Cut off the used section of the wick using nippers.
Repeat above steps if the solder is not removed completely. Absorbability may differ depending on the type of solder. Sn63% and 60% (tin content) have good absorbability.


There are no reviews yet.

Be the first to review “Desoldering Wick”

Your email address will not be published. Required fields are marked *